Paint Test Equipment P2005 Bresle Chloride Test Kit

The Paint Test Equipment P2005 Bresle Chloride Test Kit is one of the most popular tests for extracting and measuring the salt contamination on blast-cleaned substrates. This Chloride Test on steel or Salt Test on steel using the Bresle Patch or Bresle Sampler method will help to prevent coating failure due to salts such as chlorides and sulphates contaminating the surface prior to the coating application. This contamination can be tested quickly and simply using the Bresle Test. Easy to use, pour 10mls of distilled water into the beaker and determine the conductivity using the Conductivity Meter. Take a Bresle Patch and apply to the test surface. Fill the syringe with 2.5mls of test water and insert through the adhesive foam into the test chamber. Inject the contents, then extract back into the syringe. Repeat ten cycles of injecting and extracting, then transfer the test water back into the beaker. Measure the test water with the Conductivity Meter and deduct the initial conductivity reading from the result. Multiply the readings by 0.4 to give the quantity of salts in µg/cm² also known as ppm, or by 4 for the quantity of salts µg/m². The maximum permissible surface density of salts on the steel surface prior to surface treatment depends on the type of paint to be applied and what the finished material or product is to be used for. Surface treatment specifications must, therefore, state the highest permissible surface density of salts for each particular application. Complies with International Standards: ISO 8502-6 and ISO 8502-9. Bresle Test is supplied in an industrial Carrying Case with Bresle Patches (pack of 35), Horiba Conductivity Meter, Deionised Water (500ml), Syringe, 1413?S/cm Calibration Solution (14ml), Conditioning Solution (14ml) and Beaker.